This page requires Javascript. If you are installing a second hard drive, use four of the extra standard screws that are installed on the interior of the front bezel. Keep these numbers available for use when contacting customer service for assistance. HP Compaq dx Quickspecs 39 pages. HP Download and Install Assistant. If you are removing a PCI or PCI Express x1 card, hold the card at each end and carefully rock it back and forth until the connectors pull free from the socket.

Uploader: Moogukinos
Date Added: 21 June 2012
File Size: 69.70 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 70483
Price: Free* [*Free Regsitration Required]

If your system has only one SATA hard drive, you must connect the hard drive data cable to the dark blue connector labeled SATA1 to avoid any hard drive performance problems.

Type 1 Xx2810 Holder. Warranty information HP Services includes a one-year standard parts and labor warranty, pick-up or carry-in, and toll-free 7 x 24 hardware technical phone support.

RAM & SSD Upgrades | HP – Compaq dx |

Slide the drive in through the front of the chassis 1 until dx2801 screw holes on the drive are aligned with the screw holes on the drive cage and install the two M3 metric retainer screws 2 as shown in the illustration below. The technology and device width can vary between the channels.

Do hpp rely on components like the drive cage, power supply, or computer cover to push cables down into the chassis. Keep cables away from major heat sources like the heatsink. See what’s installed now.


You may install either a third-height or a half-height drive into a half-height bay. The Virtual Xd2810 is currently unavailable.

Batteries, battery packs, and accumulators should not be disposed of together with the general household waste. The M3 metric retainer screws for optical drives are black. Adherence to the procedures and precautions described in this chapter is essential for proper service.

Please try again shortly. Intel processor numbers are not a measure of performance.

Before handling a drive, ensure that you are discharged of static electricity. In any mode, the maximum operational speed is determined by the slowest DIMM in the system. The appearance of the front bezel may vary.

Intel Core 2 Quad Q Processor 2.

Download drivers for Hewlett-Packard HP dx2810 MT 103C

If you are installing a drive in a bay covered by a bezel blank, remove the front bezel then remove the bezel blank. Installing a Drive into the 3. Always populate the white sockets before the black gp in each channel.

This page requires Javascript. See your browser’s documentation for specific instructions. Heatsink retaining screws should be tightened in diagonally opposite pairs as in an X to evenly seat the heatsink on the processor.

– Driver Downloads | HP® Customer Support

You must disconnect the power cord and wait approximately 30 seconds for the power to drain before adding or removing memory modules. Discard the knockout plate.


HP Download and Install Assistant makes it easy to download and install your software. After installing a new system board, always update the system ROM to ensure that the latest version of the BIOS is being used ddx2810 the computer.

The memory module sockets have gold-plated metal contacts. If the alarm sounds, unplug the computer and leave it unplugged until the access panel is replaced.

HP COMPAQ DX2810 Quickspecs

Tell me what you’re looking for and I can help find solutions. Make sure the latches are in the closed position 3. System Board Drive Connections Refer to the following illustration and table to identify the system board drive connectors.

If you are removing a PCI or PCI Express x1 card, hold the card at each end and carefully rock it back and forth until the connectors pull free from the socket. Other resolutions may be available but are not recommended as the may not have been tested and qualified by HP.