INSTALLING CASSETTE ON XD DRIVER DOWNLOAD
Don’t have an account? I believed them and lived with it. Chesterboy Apr 29, at Seriously about to check myself into the loony bin over this creak sound. We recommend using the cassette lockring removal tool with guide pin that will not allow you to strip the lockring threads while tightening it. Installation of SRAM XD driver body-compatible cassette requires tightening two different lockrings, so please refer to the installation steps below for installing the cassette you just purchased. One of our comments on the latest Tech Spotlight pointed out we didn’t touch on the cassette – and JaseRidesBikes was absolutely correct so here it is!
|Date Added:||2 September 2006|
|File Size:||9.1 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Thanks, sounds like it might just need the extra persuasion then? I believed them and lived with it. The ping ping ping sounds like spoke issues but I was told by a few shops that its just the angle the chain makes on the 1×11 and the sound of tooth engagement with the chain.
The XD driver interface has substantial contact friction in the system, which leads riders to feel that they have torqued the assembly correctly when in fact the cassette is still loose on the driver.
I normally use Shimano cassettes which are pretty self explanatory.
XX1 Cassette Install / Creak Check
Drunk Leprechauns do a great job, especially when they team up! Then just this weekend Cassefte had to change a failed drive side bearing on cassrtte Stans 3. ReallY hope this works for me. After going through the steps described above the cassette is installed and ready for operation!
Misaligned cassette placement on the driver body may damage the cassette as well as the driver body. I start to tighten the lock ring in the middle of the cassette to pull it onto the freehub, the lock ring turns by hand with just the cassette tool probably two or three times before it goes solid.
If you have questions don’t destroy a cassette or driver. When I push the cassette onto the freehub, the splines at the back barely engage feels like 3 or 4mm before the threads on the cassette meet the threads on the freehub. Don’t have an account?
Guess I am stripping down my cassette tomorrow night! A cassette, unlike the freehub body, has key-less splines, and you can install it on the freehub in any position. No matter where I position the cassette on the freehub the depth of engagement is always the same.
Installation guidelines: XD-compatible cassette (2nd gen.)
Seriously about to check installign into the loony bin over this creak sound. We’re going to touch in specific on XX1 Cassette installation and where we have commercially found creak issues. Csasette of our comments on the latest Tech Spotlight pointed out we didn’t touch on the cassette – and JaseRidesBikes was absolutely correct so here it is! Yep, just needed winding on with the torque wrench. After that, you will need to tighten the outer lockring.
Anyone know what the torque spec is, having a difficult time finding it online.
XX1 Cassette Install / Creak Check by Nate-at-BikeCo-com – Pinkbike
MartinKS Apr 30, at I believe it’s the pins holding the 42t to the machined cassette body. Oh man do I hope this is instslling issue. Make sure the outer lockring is screwed correctly and tighten it with a removal tool.